What to look for when buying a 5 Series 520d?

2024 · 520d · 5 verified findings
"Is the 5 Serisi 520d reliable, and what should you check?"

When buying a used BMW 5 Series 520d 2024 (G60 / G61 / G90 / G99), the most frequently mentioned issue is vibration during braking (discs/pads). Carbon buildup in the EGR/EGR cooler is also commonly reported.

Engine: B47

B47D20B · 520d · Used in this car from 2018-2024

Known engine issues

  • EGR valveMost problems of this engine are related to the EGR system, called AGR here. In early years, the valve could clog at 30,000 km and a recall campaign was even conducted. When it sticks open, overheating causes the intake manifold to crack.
  • Intake cloggingThe second most frequent service issue is clogging of the intake manifold and ports in the cylinder head, leading to loss of power and unstable engine operation. In severe cases, the intake swirl flaps may stick and break off.
  • Timing chain stretchThe chain timing drive on B-series engines differs little from N-series predecessors and may require attention before 200,000 km under very active use. There is already a cost-effective procedure to replace these chains without removing the engine.

+1 more issues on the engine detail page

Known issues and risks

Listed from most frequently reported, each with its source.

Vibration during braking (discs/pads)

Often reported

Several owners of the Serie 5 G30 520d 190 HP report vibration in the cabin during braking. These vibrations can reappear even after replacing discs and pads.

Brakes

Carbon buildup in EGR/EGR cooler

Often reported

Carbon buildup in the EGR valve and intake ports is reported on the 2.0 diesel B47 190 HP engine. This can cause idle fluctuation, loss of throttle response, warning lights, and in advanced cases, heat exchanger failure.

Engine Bay

Timing chain wear/stretch (B47)

Often reported

Although the B47 engine family has fewer issues compared to the previous N47, starting noises, 'rattling' sounds, and timing chain stretch or tensioner wear are reported, especially on high-mileage or poorly maintained vehicles.

Timing chain

DPF clogging and sensor issues

Often reported

Frequently incomplete DPF regenerations, especially in city or short-distance driving, lead to warning lights, performance loss, and sensor failures.

Exhaust Emissions

Turbo/wastegate issues

Often reported

Reported faults in the turbocharger or wastegate actuator: whistling noise, loss of boost, torque drop, or unusual sounds during acceleration.

Turbo

BMW 5 Serisi 520d technical specs

BMW 5 Serisi 520d (2024): boot 560 L; fuel use 4,7 l/100 km (urban 5,4 l/100 km · extra-urban 4,3 l/100 km); 0–100 in 7.6 s.

Boot capacity
560 L
Fuel consumption
4,7 l/100 km (urban 5,4 l/100 km · extra-urban 4,3 l/100 km)
0–100 km/h
7.6 s
Top speed
222 km/s
Tire size
225/55 R17
Fuel tank
66 L
Dimensions (L×W×H)
4963 × 1868 × 1498 mm

Same trim, different year

Frequently asked questions

What should I look for when buying a BMW 5 Series 520d?+
When buying a 2024 model 520d, check the service history, perform a test drive, and look for engine/transmission warnings. The most commonly reported issues are: vibration during braking (discs/pads); carbon buildup in the EGR/EGR cooler; timing chain wear/stretch (B47).
What are the common problems of the BMW 5 Series 520d?+
The most frequently reported issues are: vibration during braking (discs/pads); carbon buildup in the EGR/EGR cooler; timing chain wear/stretch (B47).
Is the BMW 5 Series 520d reliable?+
Rather than a simple yes/no, it's better to weigh the proven pros and cons. This page lists 5 verified findings.
How does Carbeak collect data?+
The cards on this page are derived from the Difetti fault database; the source vehicle is matched to the target vehicle by brand, fuel type, engine, and generation. Topics with insufficient evidence are not shown.

We only publish claims we can verify. Cards come from Difetti fault records matched to this vehicle on brand, fuel, engine and generation.

Looking at another car?

Pick make, model and year — see the report in about 30 seconds.

Analyze now