"Is the 7 Serisi 750i reliable, and what should you check?"
When buying a used BMW 7 Series 750i 2009 (F01/F02), the most frequently mentioned issue is: Throttle body/injectors and rough running. Additionally, faulty CCV/PCV and carbon buildup are also commonly reported.
Engine: N63
N63B44A · 750i · Used in this car from 2009-2011
Strengths
Provides hurricane-like dynamics
Great tuning potential
Watch-outs
Quite high fuel consumption
Early versions have many problems
Very picky about fuel and oil
Known engine issues
Early year problemsThe first engine modifications caused a lot of trouble: rapid wear of bearings, peeling coating in cylinders, short life of timing chains, and even bursting spark plugs. However, it should be noted that all defective components were replaced under warranty without issue.
Oil consumptionThe majority of owner complaints on specialized forums are related to oil consumption. The culprits are usually stuck piston rings or hardened valve stem seals, but sometimes the cause can be a faulty crankcase ventilation system.
Coolant leaksIn some operating modes, this engine forces coolant out of the reservoir and it leaks directly onto the coils and injectors, which usually leads to serious breakdowns. Therefore, purchasing a plastic deflector to divert antifreeze is highly recommended.
Listed from most frequently reported, each with its source.
Throttle body/injectors and rough running
Often reported
In some examples, the electromechanical throttle body can stick, causing the vehicle to enter limp mode, especially around 50-80,000 km; injectors are also reported to cause rough running or engine vibration.
Engine Bay
Faulty CCV/PCV and carbon buildup
Often reported
The crankcase ventilation system (CCV/PCV) on the N63 engine can clog or fail, causing oil vapors to escape into the intake manifold and contributing to carbon buildup on valves due to direct injection.
Engine Internal
Timing chain and guide wear
Often reported
The timing chain and plastic guides on the N63 engine are prone to wear; this can lead to chain stretch, noise, rough running, and in extreme cases, timing slip causing severe engine damage.
Timing chain
Turbo failures due to oil blockage
Often reported
Turbos can be damaged by oil residue buildup (coking) and blocked oil passages, especially if the engine is consuming or leaking oil.
Turbo
BMW 7 Serisi 750i technical specs
BMW 7 Serisi 750i (2009): boot 500 L; fuel use 11,9 l/100 km (urban 17,1 l/100 km · extra-urban 8,9 l/100 km); 0–100 in 5.1 s.
Boot capacity
500 L
Fuel consumption
11,9 l/100 km (urban 17,1 l/100 km · extra-urban 8,9 l/100 km)
What should I look for when buying a BMW 7 Series 750i?+
When buying a 2009 750i, check the service history, perform a test drive, and look for engine/transmission warnings. Most commonly reported issues: throttle body/injectors and rough running; faulty CCV/PCV and carbon buildup; timing chain and guide wear.
What are the common problems of the BMW 7 Series 750i?+
Most frequently reported issues: throttle body/injectors and rough running; faulty CCV/PCV and carbon buildup; timing chain and guide wear.
Is the BMW 7 Series 750i reliable?+
Rather than a simple yes or no, it's best to weigh the proven pros and cons together. This page lists 4 verified findings.
How does Carbeak collect data?+
The cards on this page are derived from the Difetti fault database; compatibility between the source vehicle and target vehicle is verified by brand, fuel type, engine, and generation. Topics with insufficient evidence are not shown.